Commercial Carpet Wall Edge & Corner Apply Tips: How To Cut & Install Carpet Tiles to Wall Edges

Laying carpet tiles indoors isn't difficult, but the edges and corners can take more effort. For a perfect installation, not only do you need to cut to the right size for the edges and corners, but you also need to be more careful when laying them. So in this post, we go over the detailed steps for processing the edges and corners of a carpet tile installation. 

How To Cut Carpet Tile to The Wall

When you have finished pasting with the edge part, start processing the part by the wall. It is a process of cutting out the right edge of the carpet tiles that have already been pasted.

• Place one carpet tile on top of the tile carpet. This will be the carpet to cut.

• Lay it on the tile that was originally laid so that it rides directly on top without vertical and horizontal deviation.

• Then put another one, this time attached to the edge of the wall. This will be the guide.

• The yellow line of the figure formed between the first and second sheets is cut to become the part at the end.

• Apply a ruler and cut it so that it passes through the same place over and over with the cutter.

• If you try to cut it all at once, it takes a lot of strength, and it often fails.

• Spread a cutting mat or pile of newspaper so as not to damage the commercial carpet.

How To Apply Carpet Tile for Edges

• Put the cut part into the edge part.

• In the Bond section, it is written that "Let's open a little (2 ~ 3 cm) without painting the edge part of the wall", but there is no need to add Bond at this time.

• If it fits just perfectly, it will be a form of the lid with the thickness of the tile carpet.

• While preventing both ends of the tile from protruding, apply force so as to hook it to the tile that has already been pasted, and fit it toward the wall so that it is inserted.

• When the tiles come in, let's push them in the direction of the wall in order from the tiles already pasted.

• Repeat this process to paste the edges on the wall.

How To Cut and Lay Carpet Tiles in Wall Corners?

How To Cut Carpet Tile for Corners

• In the case of a corner of the room, you can think of it as doing the same work as processing the edges up and down.

• It may seem difficult because you have to cut it twice, but what you are doing is the same.

• Just like at the edge, place the tile carpet you want to cut on the first sheet so that there is no deviation on the tile carpet that has already been laid.

• Please be a little conscious of "hitting the upper wall" in the figure.

• Place the guide tiles and cut them just like you did at the edges.

• The end parts were created just like at the edges.

• Without changing the orientation of the finished part, this time consciously "hit the right wall" and put it without slipping up and down.

• Hit the guide and cut the excess bun. This completes the corner parts.

How To Apply Carpet Tile on Corners?

The way to paste the corner parts is the same as the way to the edges:

• As if hooking on an already pasted tile, stick it so that it does not slip while butting the corner to one side.

• When it fits snugly, it's as pleasant as when the last piece of the puzzle fits.

• When the part is too large, adjust it little by little and cut it so that it fits neatly.

• It is difficult to adjust in millimeters with a cutter, so it is a good idea to cut it little by little using scissors.

• If you do it this way, you can cut the corners cleanly and finish pasting the tile carpet.